SolidSheet® Installation Procedure Carefully position and mark off where SolidSheets will be applied on the road surface. Make sure markings are accurate and correspond to the road surface's shape/curve. We recommend labeling the individual parts and creating a layout guide to avoid inproper installations. Surface preparation and primer application on the road surface. Be sure to remove any and all dust, moisture, oil, etc. from the road surface. (Failure to do so may cause the peeling problems.) Apply the special primer on the marked road surface. Position the sheet. After primer solvent has vaporized, precisely place the sheet(s) in the previously marked areas. Since individual Solidsheet patterns come in separate pieces, please refer to layout guide. Heating the sheet. Begin heating the sheet with a low flame. Working from the center of the sheet, remove any air from underneath the sheet. Next, turn the gas up and melt the sheet with sufficient heating. (Please move gas burner back and forth to heat the sheet uniformly.) If you spray glass beads on the sheets after heating, nighttime reflection will be enhanced. Allow sheets to cool. After all of the above steps, please all the sheets to cool completely. (Under high temperature conditions, water can be sprayed to complete the cooling process.)